Member since Jan 2007 ·
235 posts · Location: München
Group memberships: Mitglieder
hier ist ein teil meiner Dokumentation.
Bitte sagt mir, wo Fehler sind. (Wann war Fehler?)
hier ein paar Vokabeln:
piston = Schieber
punch = Stanze
conveyor belt = Förderband
process flow description: automatic mode
At first the program controls with a light barrier, if there is a work piece in stack.
Then the piston pop out, unless the rotary table is not in home position.
Afterwards the rotary table begins to rotate, until the work piece is in punch position.
Consequentially the magnetic valve punch stamps the work piece.
After 5 seconds the rotary table rotates again 90 grad. Now the work piece is on extraction position and the second piston hits the piece on the conveyor belt.
After that the work piece drives on the conveyor belt to the end position.
There the pieces are counted by an light barrier.
Denn wer ist Gott, wenn nicht der HERR? Und wer ist ein Fels, wenn nicht unser Gott?
2.Sam 22,32